GNUNET-TESTBED-PROFILER
Section: User Commands (1)
Page Index
BSD mandoc
NAME
gnunet-testbed-profiler
- profiling driver for the testbed
SYNOPSIS
[-
c FILENAME | --config= FILENAME
]
[-
e COUNT | --num-errors= COUNT
]
[-
H FILENAME | --hosts= FILENAME
]
[-
h | -help
]
[-
L LOGLEVEL | --loglevel= LOGLEVEL
]
[-
l LOGFILE | --logfile= LOGFILE
]
[-
n | -non-interactive
]
[-
p COUNT | --num-peers= COUNT
]
[-
v | -version
]
DESCRIPTION
is a command line profiling driver for the testbed.
OPTIONS
- -c FILENAME | --config= FILENAME
-
Use the configuration file FILENAME.
- -e COUNT | --num-errors= COUNT
-
Tolerate COUNT number of continious timeout failures.
- -H FILENAME | --hosts= FILENAME
-
Name of the file with the login information for the testbed.
- -h | -help
-
Print short help on options.
- -L LOGLEVEL | --loglevel= LOGLEVEL
-
Use LOGLEVEL for logging.
Valid values are DEBUG, INFO, WARNING and ERROR.
- -l LOGFILE | --logfile= LOGFILE
-
Configure logging to write logs to LOGFILE.
- -n | -non-interactive
-
Run profiler in non-interactive mode where upon testbed setup the profiler does not wait for a keystroke but continues to run until a termination signal is received.
- -p COUNT | --num-peers= COUNT
-
Create COUNT number of peers.
- -v | -version
-
Print GNUnet version number.
SEE ALSO
The full documentation for gnunet is maintained as a Texinfo manual.
If the
info(1)
and gnunet programs are properly installed at your site, the command
info gnunet
should give you access to the complete handbook,
info gnunet-c-tutorial
will give you access to a tutorial for developers.
Depending on your installation, this information is also available in
gnunet(7)and
gnunet-c-tutorial7.
BUGS
Report bugs by using
Lk
https://bugs.gnunet.org
or by sending electronic mail to
Aq Mt
gnunet-developers@gnu.org .