Section: OpenSSL (3)
SSL_accept - wait for a TLS/SSL client to initiate a TLS/SSL handshake
int SSL_accept(SSL *ssl);
waits for a TLS/SSL
client to initiate the TLS/SSL
The communication channel must already have been set and assigned to the
by setting an underlying BIO
The behaviour of SSL_accept()
depends on the underlying BIO.
If the underlying BIO is blocking, SSL_accept() will only return once the
handshake has been finished or an error occurred.
If the underlying BIO is non-blocking, SSL_accept() will also return
when the underlying BIO could not satisfy the needs of SSL_accept()
to continue the handshake, indicating the problem by the return value -1.
In this case a call to SSL_get_error() with the
return value of SSL_accept() will yield SSL_ERROR_WANT_READ or
SSL_ERROR_WANT_WRITE. The calling process then must repeat the call after
taking appropriate action to satisfy the needs of SSL_accept().
The action depends on the underlying BIO. When using a non-blocking socket,
nothing is to be done, but select() can be used to check for the required
condition. When using a buffering BIO, like a BIO pair, data must be written
into or retrieved out of the BIO before being able to continue.
The following return values can occur:
The TLS/SSL handshake was not successful but was shut down controlled and
by the specifications of the TLS/SSL protocol. Call SSL_get_error() with the
return value ret to find out the reason.
The TLS/SSL handshake was successfully completed, a TLS/SSL connection has been
The TLS/SSL handshake was not successful because a fatal error occurred either
at the protocol level or a connection failure occurred. The shutdown was
not clean. It can also occur if action is needed to continue the operation
for non-blocking BIOs. Call SSL_get_error() with the return value ret
to find out the reason.
Copyright 2000-2020 The OpenSSL Project Authors. All Rights Reserved.
Licensed under the OpenSSL license (the ``License''). You may not use
this file except in compliance with the License. You can obtain a copy
in the file LICENSE in the source distribution or at