Section: Maintenance Commands (8)
avahi-autoipd - IPv4LL network address configuration daemon
avahi-autoipd [options] interface
avahi-autoipd --kill interface
avahi-autoipd --refresh interface
avahi-autoipd --check interface
avahi-autoipd implements IPv4LL, "Dynamic Configuration of IPv4 Link-Local Addresses" (IETF RFC3927), a protocol for automatic IP address configuration from the link-local 169.254.0.0/16 range without the need for a central server. It is primarily intended to be used in ad-hoc networks which lack a DHCP server.
IPv4LL is part of the Zeroconf stack.
avahi-autoipd can be used as stand-alone address allocator or as plugin for a DHCP client such as ISC's dhclient, where it can be used as fallback solution if no DHCP server is found.
To allow communication between hosts that have only an IPv4LL address assigned and hosts that only have a routable IP address assigned you may add the following routes to both network configurations:
route add -net 169.254.0.0 netmask 255.255.0.0 dev eth0 metric 99
route add default dev eth0 metric 99
See http://developer.apple.com/qa/qa2004/qa1357.html for more information.
- -D | --daemonize
Daemonize after startup. Implies --syslog.
- -k | --kill
Kill an already running avahi-autoipd on the specified network interface. (Equivalent to sending a SIGTERM)
- -r | --refresh
Tell an already running avahi-autoipd to re-announce the acquired IP address on the specified network interface. (Equivalent to sending a SIGHUP)
- -c | --check
Return 0 as return code if avahi-autoipd is already running for the specified network interface.
- -s | --syslog
Log to syslog instead of STDERR. Implied by --daemonize.
Enable verbose mode.
Don't drop root privileges after startup. We recommend not to use this option.
Don't chroot(2) the daemon. This option is only available when compiled with chroot() support.
- -S | --start=
Try to acquire the specified IP address, which must be from the IPv4LL range 169.254.0.0/16.
- -w | --wait
Wait until a IP address has been successfully acquired before detaching. Only valid in combination with --daemonize.
Acquire an IPv4LL address, even if a routable address has been configured on the interface.
Don't change the process name while running. Unless this option is specified avahi-autoipd will reflect its current state and the IP address in the process title.
- -h | --help
- -v | --version
Show version information.
: the script to run when an IP address as been acquired or is lost.
: avahi-autoipd will shutdown. (Same as --kill
SIGHUP: avahi-autoipd will re-announce the acquired IP address. (Same as --refresh)
The Avahi Developers <avahi (at) lists (dot) freedesktop (dot) org>; Avahi is available from http://avahi.org/
http://avahi.org/wiki/AvahiAutoipd documents how avahi-autoipd is best packaged and integrated into distributions.
This man page was written using xml2man(1)
by Oliver Kurth.