Section: Maintenance Commands (8)
ippusbxd - Communication driver for IPP-over-USB class printers
connects to a IPP-over-USB printer and exposes it to a network interface (like localhost or dummy0) on a given port, so that the printer can be accessed like an IPP network printer. The printer is also registered at Avahi to be advertised via DNS-SD on the interface, so CUPS
will auto-discover the printer for easy setup of a print queue. This requires avahi-daemon to be running and the network interface to be supported by the Avahi version in use.
Upon successful startup the TCP port it is listening on and the process ID of the daemon are printed to stdout. ippusbxd will shut itself down when the connected printer disconnects. When not specifying information about the desired printer, ippusbxd scans the USB and connects to the first available IPP-over-USB printer.
- -h, --help
Show help message.
- -v VENDOR_ID, --vid VENDOR_ID
USB vendor ID of desired printer.
- -m PRODUCT_ID, --pid PRODUCT_ID
USB product ID of desired printer.
- -s SERIAL_NUMBER, --serial SERIAL_NUMBER
Serial number of desired printer.
- --bus BUS --device DEVICE, --bus-device BUS:DEVICE
USB bus and device numbers where the device is currently connected (see output of lsusb(8)). Note that these numbers change when the device is disconnected and reconnected. This method of calling ippusbxd is only for calling via UDEV. BUS and DEVICE have to be given in decimal numbers.
- -p PORT_NUMBER, --only-port PORT_NUMBER
Port number ippusbxd will expose the printer over. If this port is already taken, ippusbxd will error out.
- -P PORT_NUMBER, --from-port PORT_NUMBER
Port number ippusbxd will expose the printer over. If this port is already taken, ippusbxd will increase the port number by 1 and try again until it finds a free port.
- -i INTERFACE, --interface INTERFACE
Network interface to use. Default is the loopback interface (lo, localhost).
- -l, --logging
Send all logging to syslog.
- -q, --verbose
Enable verbose logging.
- -d, --debug
Enables debug mode.
Implies -q and -n.
Verbose logging will be sent to stdout
- -n, --no-fork
Enables no fork mode.
- -B, --no-broadcast
No-broadcast mode, do not DNS-SD-broadcast
- -N, --no-printer
No-printer mode, debug/developer mode which makes ippusbxd run without IPP-over-USB printer
does not detect whether a USB printer is already connected by another instance of ippusbxd
, so the system/the user has to take care to not start ippusbxd
more than once for one and the same printer. Especially one should never start ippusbxd
repeatedly without specifying a printer to assure that all connected IPP-over-USB printers get their ippusbxd